NEC WL1700-MS Installation Manual - page 170
Data Assignment
Chapter 4
INITIAL SETUP
136
15
Assign data to RF of Access Point.
Select
[Wireless]
-
[Access Point Radios]
on the main menu. Click the
Edit
button to display Edit AP Radio screen. Specify the following and click the
Apply
button.
[Basic Setting 1: AP802.11b/g Radios AP No=1]
[Basic Setting 2: AP802.11a Radio AP No=1]
[Basic Setting 3: AP802.11b/g Radios AP No=2]
And then click the
Edit
button in the above items to set the following:
ITEMS
REMARKS
Mode
Mode Status
Select Enabled if the mode status is enabled.
[Basic Setting 1: Select Enabled]
Radio Profile
Select a Radio Profile for an Access Point.
[Basic Setting 1: AP1-RF1]
[Basic Setting 2: AP1-RF2]
[Basic Setting 3: AP2-RF1]
Channel
Displays the channel settings. The channel settings can
be specified in this item.
802.11a: 36, 40, 44, 48, 52, 56, 60, 64
802.11b/g: 1
–
14
[Basic Setting 1: 6]
[Basic Setting 2: 36]
[Basic Setting 3: 11]
Tx Power
Displays the transmission power information. The
transmission power information can be specified in this
item.
Use a value available in the country when specifying
the transmission power information.
[Basic Setting 1/2/3: 10]
Basic Settings