NEC WL1700-MS Installation Manual - page 193
Data Assignment
Chapter 4
INITIAL SETUP
159
5
Click the
Apply
button to apply the settings to the AP
l
When no error occur:
“
Success! You have completed configuration of this device
” is displayed.
Click the
OK
button to apply the setting to the system.
Then, the configuration data is automatically saved and the system will be
restarted.
l
When an input error occurs:
An instruction message is displayed in the screen, indicating which
parameter input is wrong.
l
When data update error occurs
If an error occurs during the data update process, the message “
Error
occurred. Do you want to reset and retry configuration? If you want to
reset, please wait for 3 minutes.
” is displayed. click the
OK
button to
restart and reset the system. In 3 minutes or later, access to the controller
by entering
http://192.168.100.10/quickstart/
in the URL box of the
Internet Explorer, and re-assign data.
Note.
The configuration of a Controller and subordinate Access Points are stored in
the WL Controller alone. When APs connect to a WL Controller, the APs downloads their
configuration files from the WL Controller.