NEC WL1700-MS Installation Manual - page 187
Data Assignment
Chapter 4
INITIAL SETUP
153
After you finished data assignment, click the
Next>
button to move to
Step3-4
screen. If an input error is in the existing screen, an instruction message will be
displayed indicating which parameter input is wrong.
Table 6. Configure Mobility Domain, when multiple controllers (such
as WL1700-MS) are used.
PARAMETERS
REMARKS
This controller will act as
Assign a role (seed or member) to
a Controller. By default,
None
is
assigned.
– None: Assigned when mobility
domain is not created.
– Seed: Assigned as seed
– Member: Assigned as member.
Domain Name
Specify a Mobility Domain name
[A maximum of 32 alphanumeric
characters, no space]. This
parameter becomes available to
input when
seed
is selected in
This controller will act as
. If no
character is assigned,
default
will
be applied.
Seed IP Addresses
Assign an IP address for
seed-functioned Controller. This
parameter becomes available to
input when
member
is selected in
This controller will act as.
Member IP Addresses #1– #5
Assign IP addresses for all of the
members in the Mobility Domain.
This parameter becomes available
to input when
seed
is selected in
This controller will act as
.