NEC WL1700-MS Installation Manual - page 126
Data Assignment
Chapter 4
INITIAL SETUP
92
20
Enable/Disable Web Authentication.
Type
set web-portal {enable | disable}
to enable/disable Web Authentication.
This function is enabled at default. The following is an example when Web
Authentication is enabled in the command.
21
Enable/Disable Simple DHCP Server function.
Type
set interface {Interface Number} ip dhcp-server {enable | disable} start
{Start IP Address} stop {End IP Address}
.
The following is an example when Simple DHCP Server is enabled in
Interface (
1
) and is to distributes IP addresses (
192.168.1.100 –
192.168.1.120
).
Note.
Simple DHCP Server function is to distribute IP addresses in a temporary
network or to make a network as demonstration. To make a real network for working
environment, please put DHCP Server in the network.
22
Create Service Profiles.
In UNIVERGE WL System, a set of data assignment for Security (Security
Policy), which can be specified per ESSID, is managed as Service Profile.
To create the Service Profile, type
set service-profile {Service Profile Name:
Up to 32 characters with no space can be specified} ssid-name {ESSID:Up
to 32 characters in ASII character can be specified}
.
The following is an example when each ESSID (
B1/B2/A1
) is added to each
Service Profile (
Dot1x-B/WPA-B/WPA-A
) in the command.
WL111111#
set web-portal
enable
WL111111#
set interface
1
ip dhcp-server
enable
start
192.168.1.100
stop
192.168.1.120
Basic Settings
WL111111#
set service-profile
Dot1x-B
ssid-name
B1
WL111111#
set service-profile
WPA-B
ssid-name
B2
WL111111#
set service-profile
WPA-A
ssid-name
A1