NEC WL1700-MS Installation Manual - page 123
Data Assignment
Chapter 4
INITIAL SETUP
89
13
Create Mobility Domain.
Mobility Domain consists of two types of Controllers: seed and member. In a
mobility domain, a single seed distributes the mobility domain information to
the members, and make a particular domain network across multiple
networks.
For examples, even if a terminal is moved to a network that does not contain
the same VLAN ID, the Controller will make connection with an appropriate
Controller by tunnelling through mobility domain. Thereby, the terminal will
be able to move from a network to another network, maintaining sessions and
the same IP address on the same VLAN ID.
a
Data Assignment on the seed side
Type
set mobility-domain mode seed domain-name {domain name:Up to
32 alphanumeric characters with no space can be specified}
.
The following is an example when domain-name (
necwlan
) is specified
in the command.
To register members to mobility domains, type
set mobility-domain
member {Member’s IP address}
. All the IP addresses of the members
have to be registered with this command.
The following is an example when a member (
192.168.10.23
) is specified
in the command.
b
Data Assignment on the member side
To register the IP address of the seed in the member-functioned
Controllers, type
set mobility-domain mode member seed-ip {Seed’s IP
address}
.
The following is an example when the seed IP address (
192.168.10.10
) is
specified in the command.
WL111111#
set mobility-domain mode seed domain-name
necwlan
WL111111#
set mobility-domain member
192.168.10.23
WL111111#
set mobility-domain mode member seed-ip
192.168.10.10