NEC WL1700-MS Installation Manual - page 124
Data Assignment
Chapter 4
INITIAL SETUP
90
14
Enable/Disable Secure Shell (SSH) service for the purpose of maintenance.
Type
set ip ssh server {enable | disable}
to enable/disable SSH service. This
function is enabled at default.
The following is an example when SSH service is enabled in the command.
15
Enable/Disable Web Interface (WebView) for the purpose of maintenance.
Type
set ip https server {enable | disable}
to enable/disable Web Console
(WebView). This function is enabled at default. The following is an example
when Web Console service is enabled in the command.
16
Enable/Disable SNMP service for the purpose of maintenance.
If you will use UNIVERGE WL Management System (WLMS), this function
must be enabled. Type
set ip snmp server {enable | disable}
. This function is
enabled at default.
The following is an example when SNMP service is enabled in the command.
17
Specify the VLANs.
Type
set vlan {VLAN ID:1–4093} name {VLAN:Up to 16 characters with no
space can be specified}
The following is an example when vlan ID (
2
) and vlan name (
necvlan
) are
specified in the command.
Type
set vlan {VLAN ID:1–4093} port {Physical Port Number:1-2} tag
{VLAN tag:1–4093}
.
The following is an example when vlan ID (
2
), Physical Port Number (
1
), and
vlan tag (
2
) are specified in the command.
18
Assign an IP address on each interface.
WL111111#
set ip ssh server
enable
WL111111#
set ip https server
enable
WL111111#
set ip snmp server
enable
WL111111#
set vlan
2
name
necvlan
WL111111#
set vlan
2
port
1
tag
2
Basic Settings