NEC WL1700-MS Installation Manual - page 125
Data Assignment
Chapter 4
INITIAL SETUP
91
Type
set interface {VLAN ID:1–4093} ip {IP Address} {Subnetmask}
to
assign IP addresses to Interfaces on the Controller.
The following is an example when vlan ID (
2
), IP address (
192.168.20.10
),
and Subnet mask (
255.255.255.0
) are specified in the command.
19
Specify the Remote Authentication Dial In User Service (RADIUS) Server.
To specify a name, type
set radius server {RADIUS Server Name: Up to 64
characters with no space can be specified}
.
The following is an example when RADIUS Server Name (
RADIUS1
),
RADIUS’s IP address (
192.168.10.100
), and a password (
pon
) are specified
in the command.
To add servers into a group, type
set server group {Server Group Name:Up to
32 characters with no space can be specified} members {Server Name 1}
[Server Name 2] [Server Name 3] [Server Name 4]
.
The following is an example when RADIUS Server Name (
RADIUS1
) is
added into a Server Group (
HOGE
) in the command.
Type
set authentication dot1x ssid {ESSID} {User Name} pass-through
{Server Group Name}
The following is an example when each ESSID (
B1/B2/B3
) is added into a
Server Group (
HOGE
) and all the users (
**
) are allowed in the command.
WL111111#
set interface
2
ip
192.168.20.10 255.255.255.0
Basic Settings
WL111111#
set radius server
RADIUS1
address
192.168.10.100
key
pon
WL111111#
set server group
HOGE
members
RADIUS1
WL111111#
set authentication dot1x ssid
B1 **
pass-through
HOGE
WL111111#
set authentication dot1x ssid
B2 **
pass-through
HOGE
WL111111#
set authentication dot1x ssid
B3 **
pass-through
HOGE