NEC WL1700-MS Installation Manual - page 120
Data Assignment
Chapter 4
INITIAL SETUP
86
Note.
Under no circumstances should you specify a country code that does not match
the country of operation. If the country of operation is not listed in this table, this might
be because the country has not yet approved the use of this equipment. In this case,
contact your local supplier before installing the equipment.
The following is an example when Country Code (
United State
) is specified in the
command.
7
Assign an IP address on each interface.
Type
set interface {VLAN ID:1–4093} ip {IP Address} {Subnetmask}
to
assign IP addresses to Interfaces on the Controller.
The following is an example when vlan ID (
1
), IP address (
192.168.10.10
),
and Subnet mask (
255.255.255.0
) are specified in the command.
8
Assign a system IP address to the Controller.
India
IN
Switzerland
CH
Ireland
IE
Taiwan
TW
Israel
IL
Thailand
TH
Italy
IT
United Arab
Emirates
AE
Japan
JP
United Kingdom
GB
Liechtenstein
LI
United States
US
Luxembourg
LU
–
–
Country
Country Code
Country Code
Country Code
WL111111
#
set system countrycode
us
Basic Settings
WL111111#
set interface
1
ip
192.168.10.10 255.255.255.0
Basic Settings