NEC WL1700-MS Installation Manual - page 121
Data Assignment
Chapter 4
INITIAL SETUP
87
Type
set system ip-address {IP Address for the Controller}
. If the system IP
address in the Controller connected to APs is changed, the controlled APs will
be reset when the Controller restarts.
The following is an example when the system IP address (
192.168.10.10
) is
specified in the command.
9
Assign the default gateway’s IP address to the Controller.
Type
set ip route default {default Gateway's IP address} [Metric:0 –
2147483647]
. The following is an example when default gateway IP address
(
192.168.10.25
) and metric (
1
) are specified in the command.
10
Specify a system name.
Type
set system name {system name:Up to 99 alphanumeric characters can
be specified}
. The following is an example when system name (
system1
) is
specified in the command.
11
Specify the prompt name.
Type
set prompt {prompt name: Up to 32 alphanumeric characters can be
specified}
. If you want to include a space in the system name, you have to
enclose the system name with quotation marks (“ ”).
The following is an example when system name (
nec
) are specified in the
command. Check to see the next prompt is changed to characters you just
entered.
12
Specify the radio type of Access Point.
WL111111#
set system ip-address
192.168.10.10
This will cause all APs to reboot. Are you sure? (y/n) [n]
y
Basic Settings
WL111111
#
set ip route default
192.168.10.25 1
Basic Settings
WL111111#
set system name
system1
WL111111#
set prompt
nec
success: change accepted.
nec#
Basic Settings