NEC WL1700-MS Installation Manual - page 208
Manual is about: UNIVERGE WL Series Wireless Controller
of
226
Configuration Management
Chapter 6
SYSTEM MAINTENANCE
174
In the case of WL1700-MS
The following explains procedures for returning WL1700-MS to factory-set
condition.
1
Insert an elongated slender rod object into the reset switch of WL1700-MS.
2
Keep pressing the reset switch for 15 seconds, using the rod.
3
When all of the LEDs light off, pull out the rod and wait until CONT STATUS
lamp lights green. It takes approximately 2 minutes to turn on.
Note.
Reset switch becomes available to use only when CONT STATUS lamp or AP
STATUS lamp lights green.
Reset Switch