NEC WL1700-MS Installation Manual - page 155

Data Assignment

Chapter 4

INITIAL SETUP

121

3

Assign an IP address to each interface. 

Select 

[Controller] 

- 

[Interfaces]

 on the main menu. Click the 

Edit

 button to 

display the Edit Interface screen, which can edit interface settings on the vlan 

(default).

Specify the following items and click the 

Apply

 button. After the system has 

restarted, if the different subnet is specified in the WL Controller, it is 

required to change the maintenance console’s setting to be in the same 

segment (subnet) with the Controller.

Note.  

The data processing between WebView might be disconnected when interface 

setting is modified. (An alert message will be indicated.) Reconnect to the modified 

interface when WebView is disconnected.

Interface Setting

ITEMS

REMARKS

Admin Status

To assign an IP address per VLAN, select Enabled.

[Basic Setting : Select Enabled]

IP Address

Specify an IP address.

[Basic Setting : 192.168.10.10]

Subnet Mask

Specify a subnet mask.

[Basic Setting : 255.255.255.0]

Basic Settings