NEC WL1700-MS Installation Manual - page 118
Data Assignment
Chapter 4
INITIAL SETUP
84
3
Specify a user name and a password, which are required for login to the
Controller.
Type
set user {user name} password [encrypted] {password: Up to 38
characters with no space can be specified}
. By default, encrypted option is
set to ON, therefore, the password will be encrypted and displayed when the
show config
command is executed. If the option (encrypted) is typed after the
command, the password will be displayed with plain text.
The following is an example when a user name (
tom
) and a password (
nec
) is
specified in the command.
4
Specify a password for entering Administrative access mode.
Type
set enablepass
. the prompt appears and asks you to type the current
password. In initial state, the password is not specified, therefore, press the
Enter key. The second and third prompts ask you to input a new password.
Type a new password twice. Note that the entered letter is not displayed in
password.
The following is an example when a password (
nec
) is specified in the
command.
5
Specify current date and time in the Controller.
l
Setting of Time Zone
Type
set timedate {zone name} {difference Time from UTC}
.
The following is an example when timezone (
5 hours before UTC
) is
specified in the command.
WL111111>
set user
tom
password
nec
WL111111>
set enablepass
Enter old password:
Enter new password:
Retype new password:
Basic Settings
WL111111#
set timedate timezone
NY -5