NEC WL1700-MS Installation Manual - page 93
Manual is about: UNIVERGE WL Series Wireless Controller
of
226
Access Point Installation
Chapter 3
INSTALLATION
59
Attaching APs to Ceiling (Flush Ceiling Tiles)
This procedure requires a T bar (23.9mm, 15/16 inch). In the case of T bars
[14mm (9/16 inch)
×
15.9mm (5/8 inch)], refer to
(DrRP Ceiling Tiles)” on page 62
Note.
The following steps are explained using WL1500-AP. In the case of installing
WL1700-MS, follow the same steps as explained below.
1
To attach an AP to ceiling, make holes in the appropriate parts of the ceiling
by using the mounting template.
2
Insert a Phillips driver into the driver slot labelled Unlock on the back, and
push it until a click is heard. Remove the mounting bracket from the WL
Access Point.
Mounting Template
UNIVERGE WL 1500-AP
Mounting Bracket