NEC WL1700-MS Installation Manual - page 80
Mounting
Chapter 3
INSTALLATION
46
Screwing the rack mounting brackets to the sides (Using open rack)
2
Mount WL Controller into 19-inch rack.
For safety purposes, this task must be done by several installers.
When mounting it into standard EIA 19-inch rack, fix two brackets firmly,
using attachment screws.
When mounting it into standard JIS 19-inch rack, screw the middle points of
two brackets using attachment screws.
Caution!
Mounting the Controller into a 19-inch rack other than recommended ones
might cause the rear module to hang from the rack. In this case, also use optional mount
brackets for rear module to secure it.
How to Mount into EIA-Standard Rack
PACT
Front
Rear
Rack Mounting Bracket (Attachment on the module)
M4 Screw
㧔
Attachment on the module
㧕
M4 Screw
(Attachment on
the module)
Rack Mounting Bracket
㧔
Attachment on the module
㧕
19-inch rack (inch type)
M5 Screw
Ether1
100M LINK 100M LIN
K
Ether2
PWR
ACT
ALM
LOAD
*Attachment on 1U BRACKET (E)
Ether1
100M LINK 100M LIN
K
Ether2
PWR
ACT
ALM
LOAD