Oce VarioStream 7000 SINGLE Operating Manual - page 137
5.8.3 Exporting a setup
A29246-X20-X-4-7680 / fa508.fm
137
5.8.3 Exporting a setup
You can also export setups for other printing systems VarioStream 7000 SINGLE.
Requirements:
• The "key operator" or an operator authorized by the key operator must be logged in.
• A setup must be loaded. The loaded setup cannot be the "default" setup.
Proceed as follows:
1.
If the printing system has not yet stopped, click the following button:
2.
On the operator panel select:
• For universally valid print job setups:
• For channel-specific setups:
3.
Select setup in the "Setup List" tab.
4.
Click on the following button:
5.
Select where the setup is to be exported:
• Floppy disk
• Transfer area (a directory on the
for the remote data transmission of setups)
6.
If exporting to a floppy disk, insert a formatted floppy disk into the floppy disk drive of
the SRA controller.
7.
Click on the following button: