Oce VarioStream 7000 SINGLE Operating Manual - page 335
7.3.11 Replacing the fine filter
A29246-X20-X-4-7680 / fa703.fm
335
2.
Clean opening with a round brush(see
section Cleaning materials and
equipment, page 365). Before use,
sharply angle round brush and insert
into the opening.
For function control, the LED must light
up when the round brush is being
inserted and go off when it is removed.
3.
Tighten the plastic screw again.
4.
Close the left and center door at the back of the printing system.
5.
Enter on the operator panel whether a new fine filter has been fitted:
•
The message on the operator panel is automatically deleted, and the replacement
of the fine filter is recorded in the
•
If the fine filter was not replaced,
the process is documented in the
Status display in the Consumables history:
Proceed as follows:
2 of 3