Oce VarioStream 7000 SINGLE Operating Manual - page 305
of
384
7.3.7 Replacing the heater
A29246-X20-X-4-7680 / fa703.fm
305
11.
Disconnect the heater connector plug
at the back of the printing system.
12.
Remove cable from the cable clamp.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Put on heat protection gloves to continue working.
Proceed as follows:
4 of 5