Oce VarioStream 7000 SINGLE Operating Manual - page 263
7.3.2 Run in photoconductor drum
A29246-X20-X-4-7680 / fa701.fm
263
7.3.2 Run in photoconductor drum
Only if the photoconductor drum is not to be run in directly after replacement:
7.3.3 Replacing the cleaning brush
Observe the following safety directives when replacing the cleaning brush:
Proceed as follows:
Important
A photoconductor drum can only be run in when printing is stopped.
1.
If the printing system has not yet stopped, click the following button:
2.
Select the
operator panel.
3.
Click the following button to run in the PC drum:
The photoconductor drum is run in after a preparation period.
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4.
Click the following button on the operator panel to complete PC drum run-in:
All printing system assemblies are checked (duration approx. 2-3 minutes) before
the printing system is switched to the "Ready" status.
•