Oce VarioStream 7000 SINGLE Operating Manual - page 319
7.3.8 Replacing the fuser roller
A29246-X20-X-4-7680 / fa703.fm
319
8.
Swivel on oiling unit and turn the oiling
unit turning knob to the right.
9.
Close the front and side door of the fuser station.
10. Select the installed fuser roller type.
11. Select installed fuser roller.
The fuser roller designation is printed on the packaging.
12. Enter on the operator panel whether a new fuser roller has been fitted:
•
The message on the operator panel is automatically deleted, and the replacement
of the fuser roller is recorded in the
•
If the fuser roller has not been replaced but only cleaned, for example,
the process is documented in the
Status display in the Consumables history:
13. Click the following button on the operator panel to complete fuser roller replacement:
All printing system assemblies are checked (duration approx. 2-3 minutes) before
the printing system is switched to the "Ready" status.
In both cases, the message on the operator panel is automatically deleted, and the
replacement of the fuser roller is recorded in the
Proceed as follows:
4 of 4