Oce VarioStream 7000 SINGLE Operating Manual - page 312
7.3.8 Replacing the fuser roller
312
A29246-X20-X-4-7680 / fa703.fm
7.3.8 Replacing the fuser roller
The following procedure is for replacing the fuser roller:
- Remove fuser roller >>> page 312
- Install new fuser roller >>> page 315
Remove fuser roller
Caution
Observe the following safety directives when replacing the fuser roller:
The fuser roller may only be replaced by operators after training or instructions from
service personnel.
Proceed as follows:
1.
If the printing system has not yet stopped, click the following button:
2.
Select the
panel.
3.
Click on the following button to start the fuser roller replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Allow the printing system to cool down for at least 30 minutes.
4.
Allow the printing system to cool down for at least 30 minutes.
1 of 4