Oce VarioStream 7000 SINGLE Operating Manual - page 297
7.3.6 Replacing the cleaning belt
A29246-X20-X-4-7680 / fa703.fm
297
7.3.6 Replacing the cleaning belt
The printing system detects the end of the cleaning belt's service life automatically and
displays a warning on the operator panel. The following procedure is for replacing the
cleaning belt:
- Remove cleaning belt >>> page 297
- Install cleaning belt >>> page 299
Remove cleaning belt
Proceed as follows:
1.
If the printing system has not yet stopped, click the following button:
2.
Select the
panel.
3.
Click the following button to start cleaning belt replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4.
Open side door of fuser station.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Do not touch any parts behind the safety covers identified with the icon
.
1 of 2