Oce VarioStream 7000 SINGLE Operating Manual - 6.11 Cleaning The Corotrons
of
384
6.11 Cleaning the corotrons
218
A29246-X20-X-4-7680 / fa605.fm
6.11 Cleaning the corotrons
Proceed as follows:
Important
Corotrons can only be cleaned when printing is stopped.
1.
If the printing system has not yet stopped, click the following button:
2.
Select the
3.
Click on the following button to start corotron cleaning:
Corotron cleaning is started. The corotrons are run in and then lowered again.
The process takes approx. 1 minute.
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4.
Click the following button on the operator panel to complete corotron cleaning:
The printing system remains in the "Stop" status.
5.
Click the following button to switch the printing system to the "Ready" status: