Oce VarioStream 7000 SINGLE Operating Manual - page 270
7.3.4.1 Preparing corotron replacement
270
A29246-X20-X-4-7680 / fa702.fm
7.3.4.1 Preparing corotron replacement
7.3.4.2 Replacing the transfer corotron (1 cartridge) (pinfed) >>> page 271
7.3.4.3 Replacing the transfer corotron (torn wire) (pinfed) >>> page 275
Important
Observe the safety directives before replacing the corotron(see section 7.3.4
Replacing corotrons, page 269).
Proceed as follows:
Important
This section only applies if the message "Replace corotrons" is displayed. All
corotrons must now be replaced.
When a corotron wire has torn, the replacement is carried out according to Abschnitt
7.3.5.3, Abschnitt 7.3.4.7 or Abschnitt 7.3.4.5.
1.
If the printing system has not yet stopped, click the following button:
2.
Select the
panel.
3.
Click the following button to start corotron replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4.
Click the following button to move corotrons to the test position:
5.
Open the cover and both doors at the front of the printing system.