Oce VarioStream 7000 SINGLE Operating Manual - page 260
of
384
7.3.1 Replacing the photoconductor drum
260
A29246-X20-X-4-7680 / fa701.fm
Install the the photoconductor drum
9.
Grasp the photoconductor drum by the
handle frame and quickly pull out of the
printing system in a horizontal
direction.
10. Put down photoconductor drum.
11.
• Clean the toner mark sensor (left)
with a soft cloth.
• Clean the (lower) charge sensor with
a clean soft brush.
Caution
Observe the safety directives before installing the photoconductor drum(see section
7.3.1 Replacing the photoconductor drum, page 257).
Proceed as follows:
3 of 3