Oce VarioStream 7000 SINGLE Operating Manual - page 99
5.3 After print stop, switch the printing system back to "Ready"
A29246-X20-X-4-7680 / fa501.fm
99
5.3 After print stop, switch the printing system back to "Ready"
A print stop may have the following causes:
• The controller has run out of data.
The printing system is in "Ready" status and continues printing automatically as soon as
print data is available again.
• The STOP key was pressed on the operator panel.
The printing system is in "Stop" status.
To switch the printing system back to "Ready":
• The printing system was stopped by an error message.
Information on switching to ready after a stop caused by an error: see section 8.2.2
Continuing printing after errors have been corrected, page 341.
Proceed as follows:
1.
Click on the following button:
Print operation continues without any impairment to print or fusing quality. The
temperature of the fuser station decreases in stages with longer standby times. For
this reason, the fuser station may first have to be reheated to its operating
temperature. Depending on the type of paper, this may take up to 30 seconds.