ABB SA/S 12.16.6.1 Product Manual - Knx Commissioning
ABB i-bus
®
KNX Commissioning
46 2CDC 505 056 D0207 | SA/S
The following operating modes are available for each output of a Switch
Actuator:
Switch Actuator
For “normal” switching, e.g. of lighting.
The output is controlled directly via the communication object
Switch
. A large number of additional functions (time, logic, safety,
etc.) are possible.
For further information see:
, page 133
Heating Actuator
For control of heating valves, e.g. in an individual room
temperature control system. A room thermostat sends a control
value, which the output uses to control the valve, e.g. as a 2-step
control.
For further information see:
, page 133
Note
With the introduction of optimised current detection, on all Switch Actuator
types the nomenclature for status messages, e.g. Telegr.status switch,
Thermostat fault
, has been converted to the nomenclature without Telegr.,
e.g. Status Switch, RTR fault.