ABB SA/S 12.16.6.1 Product Manual - Knx Commissioning
ABB i-bus
®
KNX Commissioning
94 2CDC 505 056 D0207 | SA/S
3.2.3.1.7 Parameter window
A: Current Detection
In this parameter window, all settings for the function Current Detection are
undertaken.
This parameter is visible if in parameter window
, page 64, the
parameter Enable function “current detection” has been enabled.
Note
The function current detection and the respective parameter window are
only visible with the Switch Actuators with current detection (SA/S
x.16.6.1). They are both equally available in the Switch Actuator and
Heating Actuator
modes.
The settings in the parameter window A: Current Detection determine if and
how the load current of the output is evaluated. With activated current
detection, the communication object Current Value is enabled.
Using the communication object Current Value the detected current value is
transferred as a mA value on the KNX. The current value is a sine wave
converter to an RMS value.
For further information see: