ABB SA/S 12.16.6.1 Product Manual - Knx Commissioning
ABB i-bus
®
KNX Commissioning
78 2CDC 505 056 D0207 | SA/S
Number of ON-impulses: (1…100)
Options: 1…5…100
This parameter defines the maximum number of flash pulses. This is useful
to avoid unnecessary wear of the contacts caused by flashing.
Contact position after
flashing
This parameter defines the state that the parameter should assume after
flashing.
ON: The output is switched on after flashing.
OFF: The output is switched off after flashing.
calculate present contact position: The output assumes the switching
state, which it had before flashing commenced.
For further information see:
, page 139
Note: Observe contact life and switching
frequency per minute
Note
Only a certain number of switching actions are possible per minute and
Switch Actuator. With frequent switching, a switching delay can occur, as
only a certain number of switching actions are possible per minute, see
, from page 7. The same applies directly after bus voltage
recovery.