Jeep 1996 Grand Cherokee Service Manual - page 1068
bracket. Lift the cable housing straight up from
bracket while pressing on release tab. Remove throt-
tle cable from vehicle.
INSTALLATION
(1) 4.0L Engine: Slide throttle cable through hole
in throttle body bracket until retainer tabs lock into
bracket. Connect cable ball end to throttle body link-
age ball (snaps on).
(2) 5.2L Engine: Connect cable ball end to throttle
body linkage ball (snaps on). Connect cable to throt-
tle body bracket (push down and lock).
(3) 4.0L Engine: Snap cable into clip on engine
valve cover and clip at dash panel.
(4) Push other end of cable through opening in
dash panel until retaining tabs lock into panel.
(5) From inside drivers compartment, slide throttle
cable core wire into opening in top of pedal arm.
Push cable retainer (clip) into pedal arm opening
until it snaps in place.
(6) Before
starting
engine,
operate
accelerator
pedal to check for any binding.
SPECIFICATIONS
VECI LABEL SPECIFICATIONS
If anything differs between the specifications found
on the Vehicle Emission Control Information (VECI)
label and the following specifications, use specifica-
tions on VECI label. The VECI label is located in the
engine compartment.
FUEL TANK CAPACITY
FUEL SYSTEM PRESSURE
338 kPa
6 14 kPa (49.0 psi 6 2 psi).
TORQUE CHART
DESCRIPTION
TORQUE
Accelerator Pedal Bracket
Mounting Nuts . . . . . . . . . . . . .10 N·m (92 in. lbs.)
Fuel Filter Mounting Strap Bolt . .7 N·m (66 in. lbs.)
Fuel Pump Module Locknut . . . . .54 N·m (40 ft. lbs.)
Fuel Rail Mounting Bolts—
4.0L Engine . . . . . . . . . . . . . . . .27 N·m (20 ft. lbs.)
Fuel Rail Mounting Bolts—
5.2L Engine . . . . . . . . . . . . . .23 N·m (200 in. lbs.)
Fuel Tank Mounting Nuts . . . .Refer To Manual Text
Fuel Hose Clamps . . . . . . . . . . . . .1 N·m (15 in. lbs.)
Fig. 41 Cable Release Tab—5.2L Engines—Typical
Models
Liters
U.S. Gallons
All
87
23
Nominal refill capacities are shown. A variation may be
observed from vehicle to vehicle due to manufacturing
tolerance and refill procedure.
ZJ
FUEL SYSTEM
14 - 23
REMOVAL AND INSTALLATION (Continued)