Jeep 1996 Grand Cherokee Service Manual - page 353
SPEED CONTROL SWITCHES
REMOVAL/INSTALLATION
WARNING:
BEFORE BEGINNING ANY AIRBAG
SYSTEM COMPONENT REMOVAL OR INSTALLA-
TION, REMOVE AND ISOLATE THE NEGATIVE (-)
CABLE FROM THE BATTERY. THIS IS THE ONLY
SURE WAY TO DISABLE THE AIRBAG SYSTEM.
THEN WAIT TWO MINUTES FOR SYSTEM CAPACI-
TOR TO DISCHARGE BEFORE FURTHER SYSTEM
SERVICE. FAILURE TO DO THIS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE INJURY.
(1) Disconnect and isolate negative battery cable.
(2) Remove airbag module. Refer to Group 8M for
procedures.
(3) Remove
switch-to-steering
wheel
mounting
screw (Fig. 4).
(4) Remove switch.
(5) Reverse removal procedures to install.
STOP LAMP SWITCH
Refer to Group 5, Brakes for removal/installation
and adjustment procedures.
SERVO CABLE
REMOVAL/INSTALLATION
(1) 4.0L
Engine:
Using
finger
pressure
only,
remove speed control cable connector at throttle body
bellcrank pin by pushing connector off the bellcrank
towards the drivers side of vehicle (Fig. 5). DO NOT
try to pull connector off perpendicular to the
bellcrank pin. Connector will be broken.
(2) 5.2L
Engine:
Using
finger
pressure
only,
remove speed control cable connector at throttle body
bellcrank by pushing connector rearward off the
bellcrank pin (Fig. 6). DO NOT try to pull connec-
tor off perpendicular to the bellcrank pin. Con-
nector will be broken.
(3) 4.0L Engine: Remove cable from cable guide at
top of valve cover (Fig. 7).
(4) Squeeze 2 tabs on sides of speed control cable
at throttle body mounting bracket (locking plate) and
push out of bracket.
Fig. 4 Speed Control Switches
Fig. 5 Cable at Bell Crank—4.0L Engine
Fig. 6 Cable at Bell Crank—5.2L V-8 Engine
8H - 8
VEHICLE SPEED CONTROL SYSTEM
ZJ
REMOVAL AND INSTALLATION (Continued)