Jeep 1996 Grand Cherokee Service Manual - page 1240
(9) Install thrust bearing on overrunning clutch
hub (Fig. 282). Use generous amount of petroleum
jelly to hold bearing in place for installation. Bear-
ing fits one way only. Be sure bearing is seated
squarely against hub. Reinstall bearing if it
does not seat squarely.
(10) Install overrunning clutch in output shaft
(Fig. 283). Insert snap ring pliers in hub splines.
Expand pliers to grip hub. Then install assembly
with counterclockwise, twisting motion.
(11) Install planetary gear in annulus gear (Fig.
284). Be sure planetary pinions are fully seated
in annulus gear before proceeding.
(12) Install direct clutch spring plate on sun gear.
Shoulder side of plate should face outward and
toward front. Then secure plate to sun gear with
snap ring (Fig. 285).
Fig. 282 Overrunning Clutch Thrust Bearing Installation
Fig. 283 Overrunning Clutch Installation
Fig. 284 Planetary Gear Installation
Fig. 285 Sun Gear And Spring Plate Assembly
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 101
DISASSEMBLY AND ASSEMBLY (Continued)