Jeep 1996 Grand Cherokee Service Manual - page 1219
(4) Remove pump-to-support bolts and separate
support from pump housing (Fig. 197).
(5) Remove inner and outer gears from reaction
shaft support (Fig. 198).
(6) If pump seal was not removed during transmis-
sion disassembly, remove seal with punch and ham-
mer.
(7) Remove front clutch thrust washer from sup-
port hub (Fig. 199).
OIL PUMP BUSHING REPLACEMENT
(1) Remove
pump
bushing
with
Tool
Handle
C-4171 and Bushing Remover SP-3551 (Fig. 200).
(2) Install new pump bushing with Tool Handle
C-4171 and Bushing Installer SP-5117 (Fig. 200).
Bushing should be flush with pump housing bore.
(3) Stake new pump bushing in two places with
blunt punch (Fig. 201). Remove burrs from stake
points with knife blade afterward.
REACTION SHAFT SUPPORT BUSHING REMOVAL
(1) Assemble Bushing Remover Tools SP-1191,
3633 and 5324 (Fig. 202). Do not clamp any part
of reaction shaft or support in vise.
(2) Hold Cup Tool SP-3633 firmly against reaction
shaft and thread remover SP-5324 into bushing as
Fig. 197 Separating Pump Housing From Reaction
Shaft Support
Fig. 198 Pump Gear Removal
Fig. 199 Oil Pump And Reaction Shaft Support Components
21 - 80
TRANSMISSION AND TRANSFER CASE
ZJ
DISASSEMBLY AND ASSEMBLY (Continued)