Jeep 1996 Grand Cherokee Service Manual - page 1535
Manual is about: 1996 ZJ Jeep Grand Cherokee
of
1551
(10) Install new seal in front bearing retainer with
Tool Handle C-4171 and Installer 7884 (Fig. 52).
Replace output shaft rear bearing (Fig. 53). Remove
bearing with internal puller and slide hammer.
(12) Install new bearing with Tool Handle C-4171
and Installer 5066. Lubricate bearing after installa-
tion.
(13) Install new seal in oil pump feed housing with
Special Tool 7888 (Fig. 54).
Fig. 53 Front Output Shaft Rear Bearing Installation
Fig. 54 Oil Pump Seal Installation
Fig. 51 Input Gear Pilot Bearing Removal
Fig. 52 Front Bearing Retainer Seal Installation
21 - 16
TRANSMISSION AND TRANSFER CASE
ZJ
DISASSEMBLY AND ASSEMBLY (Continued)