Jeep 1996 Grand Cherokee Service Manual - page 340
REAR DOOR
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the door trim panel mounting screw
located in the bezel opening near the inside door
latch release handle (Fig. 13).
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(6) Unplug the wiring connector from the power
window switch.
(7) Remove the three screws holding the speaker
to the lower front corner of the inner door panel (Fig.
14).
(8) Disconnect the speaker wiring connector and
remove the speaker.
(9) Reverse the removal procedures to install.
Tighten the hardware as follows:
• speaker mounting screws - 1.1 N·m (10 in. lbs.)
• trim panel mounting screws - 1.3 N·m (12 in.
lbs.).
ANTENNA
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP
8M
-
PASSIVE
RESTRAINT
SYSTEMS
BEFORE
ATTEMPTING
STEERING
WHEEL,
STEERING
COLUMN,
OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the right front inner fender liner. Refer
to Group 23 - Body Components for the procedures.
(3) Unscrew the antenna mast from the antenna
body (Fig. 15).
Fig. 13 Rear Door Trim Panel Remove/Install
Fig. 14 Rear Door Speaker Remove/Install
Fig. 15 Antenna Mast Remove/Install - Typical
ZJ
AUDIO SYSTEMS
8F - 11
REMOVAL AND INSTALLATION (Continued)