Jeep 1996 Grand Cherokee Service Manual - page 1377
REAR DOOR SCUFF PLATE
REMOVAL
The rear door scuff plate is attached with mold-
ed-in snap retainers.
(1) Using a trim stick or similar tool, carefully pry
scuff plate from sill. Detach scuff plate from sill (Fig.
42).
INSTALLATION
(1) Position scuff plate on sill and snap into place.
C-PILLAR TRIM
REMOVAL
(1) Remove rear seat belt turning loop.
(2) Using a trim stick, carefully pry C-pillar trim
panel from vehicle (Fig. 40).
INSTALLATION
(1) Position C-pillar trim panel on C-pillar and
snap into place.
(2) Install rear seat belt turning loop.
QUARTER TRIM PANELS
(1) Pull rear seat bottom forward and fold down
rear seat.
(2) Remove lower retaining screw at rear door
opening (Fig. 40).
(3) If equipped, remove sunshade cover.
(4) Remove C-pillar trim panel.
(5) Remove screws retaining upper liftgate trim
panel.
(6) Disconnect wiring to cargo lamp.
(7) Remove liftgate lower trim panel from liftgate
opening.
(8) Remove quarter trim panel mounting screws.
(9) If necessary, remove spare tire and tire stand-
offs from left quarter trim panel (Fig. 44).
(10) Remove rear quarter trim panel.
INSTALLATION
(1) Reverse removal procedure.
D-PILLAR TRIM
REMOVAL
(1) Remove liftgate upper trim panel (Fig. 45).
(2) Detach and remove trim panel from D-pillar
(Fig. 40).
INSTALLATION
(1) Position D-pillar trim panel on D-pillar and
snap in place.
(2) Install upper liftgate trim panel.
FRONT SHOULDER BELT/BUCKLE
REMOVAL—BUCKLE
(1) Slide front seats all the way forward for access
to buckle anchor bolt.
(2) Disconnect buckle wire harness connector.
(3) Remove anchor bolt cover.
(4) Remove buckle anchor bolt.
(5) Remove shoulder belt buckle from transmission
tunnel.
INSTALLATION—BUCKLE
(1) Position seat belt buckle in position and anchor
bolt.
(2) Install anchor bolt cover.
(3) Disconnect buckle wire harness connector.
Fig. 44 Tire Stand-Offs—Left Quarter Trim Panel
Fig. 45 Liftgate Opening Trim Panels
23 - 34
BODY
ZJ
REMOVAL AND INSTALLATION (Continued)