Jeep 1996 Grand Cherokee Service Manual - page 1209
(8) Install and tighten overrunning clutch cam
bolts to 17 N·m (13 ft. lbs.) torque. Note that clutch
cam bolts are shorter than piston retainer bolts.
(9) Lubricate clutch cam rollers with transmission
fluid.
(10) Install rear band reaction pin (Fig. 159). Be
sure pin is fully seated in case.
(11) Install rear band in case (Fig. 160). Be sure
twin lugs on band are seated against reaction pin.
(12) Install low-reverse drum and check overrun-
ning clutch operation as follows:
(a) Lubricate overrunning clutch race (on drum
hub) with transmission fluid.
(b) Guide drum through rear band.
(c) Tilt drum slightly and start race (on drum
hub) into overrunning clutch rollers.
(d) Press drum rearward and turn it in clock-
wise direction until drum seats in overrunning
clutch (Fig. 161).
(e) Turn drum back and forth. Drum should
rotate freely in clockwise direction and lock
Fig. 157 Location Of Blank Area In Clutch Cam Bolt
Circle
Fig. 159 Installing Rear Band Reaction Pin
Fig. 160 Rear Band Installation
Fig. 161 Installing Low-Reverse Drum
Fig. 158 Overrunning Clutch Installation
21 - 70
TRANSMISSION AND TRANSFER CASE
ZJ
DISASSEMBLY AND ASSEMBLY (Continued)