Jeep 1996 Grand Cherokee Service Manual - page 1216
(e) Tighten each adjusting screw locknut. Hold
adjusting screws with wrench to prevent turning
when tightening locknut.
(56) Install seal on park/neutral position switch
(Fig. 185). Then install and tighten switch to 34 N·m
(25 ft. lbs.).
(57) Install magnet in oil pan. Magnet goes on
small protrusion at corner of pan.
(58) Position new oil pan gasket on case and
install oil pan. Tighten pan bolts to 17 N·m (13 ft.
lbs.).
(59) Install new valve body manual shaft seal in
case (Fig. 186). Lubricate seal lip and manual shaft
with petroleum jelly. Start seal over shaft and into
case. Seat seal with 15/16 inch, deep well socket.
(60) Install throttle valve and shift selector levers
on valve body manual lever shaft.
(61) Cap or cover transmission openings (cooler
line fittings, filler tube bore, etc.) to prevent dirt
entry.
(62) Install torque converter. Use C-clamp or metal
strap to hold converter in place for installation.
(63) Install transmission speed sensor in overdrive
case (Fig. 187).
(64) Mount transmission on jack for installation in
vehicle.
(65) Apply dielectric grease to terminal pins of
solenoid case connector and neutral switch.
OVERRUNNING CLUTCH/LOW-REVERSE DRUM
DISASSEMBLE
If the clutch assembly came out with the low-re-
verse drum, thread two clutch cam bolts into the
cam. Then lift the cam out of the drum with the bolts
(Fig. 188). Rotate the cam back and forth to ease
removal if necessary. Remove the clutch roller and
spring assembly from the race afterward.
Fig. 185 Park/Neutral Position Switch Seal Position
Fig. 186 Installing Manual Lever Shaft Seal
Fig. 187 Transmission Speed Sensor
Fig. 188 Removing Overrunning Clutch From
Low-Reverse Drum
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 77
DISASSEMBLY AND ASSEMBLY (Continued)