Jeep 1996 Grand Cherokee Service Manual - page 354
(5) Remove servo cable from servo. Refer to Speed
Control Servo removal and installation in this group.
(6) Reverse removal procedures to install.
POWERTRAIN CONTROL MODULE
For Removal/Installation refer to Group 14, Fuel
Injection System.
VACUUM RESERVOIR
REMOVAL/INSTALLATION
(1) Disconnect both battery cables, negative cable
first.
(2) Remove battery holddowns.
(3) Remove battery from battery tray.
(4) Remove 5 bolts securing battery tray.
(5) Pull up battery tray and remove vacuum line
from reservoir (Fig. 8).
(6) Remove 2 screws holding reservoir to battery
tray.
(7) Reverse removal procedures to install. Tighten
hardware as follows:
• vacuum reservoir mounting bolts to 3 N·m (30
in. lbs.)
• battery tray mounting bolts to 10 N·m (90 in.
lbs.)
• battery holddown bolts to 10 N·m (90 in. lbs.)
• battery cable clamp bolts to 8.5 N·m (75 in. lbs.).
VEHICLE SPEED SENSOR
For Removal/Installation of the Vehicle Speed Sen-
sor refer to Group 21, Transaxle..
SPECIFICATIONS
TORQUE
Description
Torque
Servo Mounting Bracket-to-Servo
Nuts. . . . . . . . . . . . . . . . . . . . .8.5 N·m (75 in. lbs.)
Servo Mounting Bracket-to-Body
Nuts . . . . . . . . . . . . . . . . . . . . . .5 N·m (47 in. lbs.)
Switch Module Mounting
Screws . . . . . . . . . . . . . . . . . . .1.5 N·m (15 in. lbs.)
Vacuum Reservoir Mounting
Bolts . . . . . . . . . . . . . . . . . . . . . .4 N·m (35 in. lbs.)
Fig. 7 Cable Guide/Locking Plate—4.0L Engine
Fig. 8 Vacuum Reservoir
ZJ
VEHICLE SPEED CONTROL SYSTEM
8H - 9
REMOVAL AND INSTALLATION (Continued)