Jeep 1996 Grand Cherokee Service Manual - page 1348
(5) Apply black-out primer 15 mm (.75 in.) wide on top
and sides of windshield and 25 mm (1 in.) on bottom of
windshield. Allow at least three minutes drying time.
(6) Position windshield spacers on lower fence
above support spacers at the edge of the windshield
opening (Fig. 1).
(7) Apply a 10 mm (0.4 in.) bead of urethane around
perimeter of windshield along the inside of the mold-
ings. Apply two beads along the bottom edge.
(8) Install upper molding onto windshield.
(9) Apply fence primer around the perimeter of the
windshield opening fence. Allow at least 18 minutes drying
time.
(10) With aid of a helper, position windshield over
windshield opening. Align reference marks at bottom
of windshield to support spacers.
(11) Slowly lower windshield glass to windshield
opening fence. Guide top molding into proper position
if necessary. Push windshield inward to fence spacers
at bottom and until top molding is flush to roof line.
(12) Clean excess urethane from exterior with
Mopar Super Clean or equivalent.
(13) Install windshield side moldings.
(14) Install cowl cover and wipers.
(15) Install inside rear view mirror.
(16) After urethane has cured, water test wind-
shield to verify repair.
Fig. 1 Windshield
Fig. 2 Cut Urethane Around Windshield—Typical
Fig. 3 Center Windshield and Mark at Support Spacers
ZJ
BODY
23 - 5
REMOVAL AND INSTALLATION (Continued)