Jeep 1996 Grand Cherokee Service Manual - page 1190
VALVE BODY UPPER HOUSING DISASSEMBLE
(1) Note location of check balls in valve body upper
housing (Fig. 90). Then remove the one large diame-
ter and the six smaller diameter check balls.
(2) Remove E-clip that secure shuttle valve second-
ary spring on valve stem (Fig. 91).
(3) Remove governor plug and shuttle valve covers
(Fig. 92).
(4) Remove throttle plug, primary spring, shuttle
valve, secondary spring, and spring guides (Fig. 92).
(5) Remove boost valve retainer, spring and valve
if not previously removed.
(6) Turn upper housing over and remove switch
valve, regulator valve and spring, and manual valve
(Fig. 93).
(7) Remove kickdown detent, kickdown valve, and
throttle valve and spring (Fig. 93).
(8) Remove throttle plug and 1-2 and 2-3 governor
plugs (Fig. 93). Also remove shuttle valve primary
spring if not removed in prior step.
Fig. 90 Check Ball Locations In Upper Housing
Fig. 91 Shuttle Valve E-Clip And Secondary Spring
Location
Fig. 88 Upper Housing Separator Plate
Fig. 89 Rear Clutch And Rear Servo Check Ball
Locations
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 51
DISASSEMBLY AND ASSEMBLY (Continued)