Jeep 1996 Grand Cherokee Service Manual - page 1115
(8) Stop the engine and check the fluid level and
refill as required.
(9) If the fluid is extremely foamy, allow the vehi-
cle to stand a few minutes and repeat the procedure.
REMOVAL AND INSTALLATION
POWER STEERING PUMP — 4.0L
REMOVAL
(1) Remove serpentine drive belt, refer to Group 7
Cooling.
(2) Vehicles equipped with Speed Proportional
Steering, disconnect actuator harness.
(3) Remove pressure and return hoses from pump
and drain pump.
(4) Remove 3 pump mounting bolts through pulley
access holes.
(5) Loosen the 3 pump bracket bolts (Fig. 3).
(6) Tilt pump downward and remove from engine.
(7) Remove pulley from pump.
INSTALLATION
(1) Install pulley on pump.
(2) Install pump on engine.
(3) Tighten pump bracket bolts to 47 N·m (35 ft.
lbs.).
(4) Install 3 pump mounting bolts and tighten to
27 N·m (20 ft. lbs.).
(5) Install the pressure and return hoses to pump.
(6) Vehicles equipped with Speed Pro Steering,
connect actuator harness.
(7) Install drive belt, refer to Group 7 Cooling.
(8) Add power steering fluid. Refer to Power Steer-
ing Pump Initial Operation in this section.
POWER STEERING PUMP — 5.2L
REMOVAL
(1) Remove the serpentine drive belt. Refer to
Group 7 Cooling.
(2) Remove the pressure and return hoses from
pump and drain pump.
(3) Vehicles equipped with Speed Proportional
Steering, disconnect actuator harness.
(4) Remove pump mounting bolts and remove the
pump (Fig. 4).
(5) Remove pulley from pump.
Fig. 3 Pump Mounting
Fig. 4 Power Steering Pump — 5.2L
19 - 6
STEERING
ZJ
SERVICE PROCEDURES (Continued)