Jeep 1996 Grand Cherokee Service Manual - page 415
(2) Remove the three screws securing the seat side
shield to the seat cushion frame and pull the shield
away from the seat so that the power recliner
adjuster lower bracket can be seen.
(3) Adjust the seat back with the power recliner
switch so that both of the two bolts in the power
recliner adjuster lower bracket can be accessed.
(4) Disconnect and isolate the battery negative
cable.
(5) Remove the two bolts securing the power
recliner adjuster lower bracket to the seat cushion
frame.
(6) Gently pry the power recliner adjuster lower
bracket upwards to access the heated seat control
module mounting screw (Fig. 2).
(7) Remove the mounting screw from the seat
cushion frame.
(8) Reach under the rear of the seat cushion to
lower the heated seat control module and mounting
bracket unit from the inside of the seat cushion
frame (Fig. 3).
(9) Unplug the wiring connector and remove the
module from under the seat.
(10) Reverse the removal procedures to install.
Tighten the power recliner adjuster lower bracket
bolts to 28 N·m (20 ft. lbs.).
Fig. 1 Right Switch Pod Remove/Install
Fig. 2 Heated Seat Control Module Remove/Install
Fig. 3 Heated Seat Control Module
8N - 10
ELECTRICALLY HEATED SYSTEMS
ZJ
REMOVAL AND INSTALLATION (Continued)