Jeep 1996 Grand Cherokee Service Manual - page 1324
(33) Align and install rear case on front case (Fig.
57).
(34) Verify that oil pickup tube is still seated in
case notch and tube end is pointed toward mainshaft
(Fig. 58).
(35) Install case attaching bolts. Alignment bolts at
each end of case are only ones requiring washers (Fig.
59).
(36) Tighten case bolts to 27-34 N·m (20-25 ft. lbs.)
torque.
(37) Install oil pump (Fig. 60).
(38) Insert oil pickup tube in pump (Fig. 61).
(39) Install rear bearing on mainshaft (Fig. 61).
Locating ring groove in bearing goes toward end of
mainshaft.
(40) Install rear bearing retaining snap ring (Fig. 62).
(41) Install speedometer drive gear (Fig. 63).
Fig. 57 Rear Case Installation
Fig. 58 Checking Position Of Oil Pickup Tube
Fig. 59 Alignment Bolt Location
Fig. 60 Installing Oil Pump
Fig. 61 Rear Bearing Installation
Fig. 62 Rear Bearing Snap Ring Installation
Fig. 63 Speedometer Drive Gear Installation
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 185
DISASSEMBLY AND ASSEMBLY (Continued)