Jeep 1996 Grand Cherokee Service Manual - page 1246
OVERDRIVE CLUTCH INSTALLATION
(1) Install overdrive clutch reaction ring first.
Reaction ring is flat with notched ends (Fig. 306).
(2) Install wave spring on top of reaction ring (Fig.
307). Reaction ring and wave ring both fit in
same ring groove. Use screwdriver to seat each
ring securely in groove.
(3) Assemble overdrive clutch pack (Fig. 308).
(4) Install overdrive clutch reaction plate first.
Note that reaction plate is thinner than pres-
sure plate.
(5) Install first clutch disc followed by first clutch
plate. Then install remaining clutch discs and plates
in same order.
(6) Verify clutch pack. 3 clutch discs, 2 steel plates,
1 reaction plate and 1 pressure plate are required.
(7) Install clutch pack pressure plate. Note that
pressure plate is thickest plate in clutch pack.
(8) Install clutch pack wire-type retaining ring
(Fig. 309).
Fig. 306 Overdrive Clutch Reaction Ring Installation
Fig. 307 Overdrive Clutch Wave Spring Installation
Fig. 308 Overdrive Clutch Components
Fig. 309 Overdrive Clutch Pack Retaining Ring
Installation
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 107
DISASSEMBLY AND ASSEMBLY (Continued)