Jeep 1996 Grand Cherokee Service Manual - page 474
(9)
Connect connector to its mating half/compo-
nent.
(10) Connect battery and test all affected systems.
CONNECTOR AND TERMINAL REPLACEMENT
(1) Disconnect battery.
(2)
Disconnect the connector (that is to be
repaired) from its mating half/component.
(3)
Cut off the existing wire connector directly
behind the insulator. Remove six inches of tape from
the harness.
(4)
Stagger cut all wires on the harness side at
1/2 inch intervals (Fig. 20).
(5) Remove 1 inch of insulation from each wire on
the harness side.
(6) Stagger cut the matching wires on the repair
connector assembly in the opposite order as was done
on the harness side of the repair. Allow extra length
for soldered connections. Check that the overall
length is the same as the original (Fig. 20).
(7) Remove 1 inch of insulation from each wire.
(8)
Place a piece of heat shrink tubing over one
side of the wire. Be sure the tubing will be long
enough to cover and seal the entire repair area.
(9) Spread the strands of the wire apart on each
part of the exposed wires.
(10)
Push the two ends of wire together until the
strands of wire are close to the insulation.
(11) Twist the wires together.
(12)
Solder the connection together using rosin
core type solder only. Do not use acid core solder.
(13)
Center the heat shrink tubing over the joint
and heat using a heat gun. Heat the joint until the
tubing is tightly sealed and sealant comes out of both
ends of the tubing
(14)
Repeat steps 8 through 13 for each wire.
(15) Re-tape the wire harness starting 1-1/2 inches
behind the connector and 2 inches past the repair.
(16) Re-connect the repaired connector.
(17) Connect the battery, and test all affected sys-
tems.
Fig. 17 Connector Locking Wedge
Fig. 18 Terminal Removal
Fig. 19 Terminal Removal Using Special Tool
Fig. 20 Stagger Cutting Wires
ZJ
8W - 01 GENERAL INFORMATION
8W - 01 - 9
SERVICE PROCEDURES (Continued)