Jeep 1996 Grand Cherokee Service Manual - page 1299
(10) Install new seal in input retainer with Tools
C-4171 and 7884 (Fig. 54).
(11) Apply 3 mm bead of Mopar Sealer P/N
82300234, or Loctite Ultra Gray to front bearing
retainer seal surface (Fig. 55).
(12) Align oil channel in retainer with oil feed hole
in front case (Fig. 56).
(13) Align and install input retainer on front case
(Fig. 57).
(14) Install and tighten input retainer bolts to
16–24 N.m (12–18 ft. lbs.) torque.
SHIFT SECTOR/POPPET/RANGE FORK/RANGE HUB
INSTALLATION
(1) Install shift sector O-ring and nylon retainer in
case bore. Note that one side of retainer is slightly
rounded and that the opposite side has a shallow
groove. Groove side goes toward seal and rounded
side faces out.
(2) Install shift sector in case (Fig. 58). Lubricate sec-
tor shaft with transmission fluid before installation.
Fig. 54 Input Retainer Seal Installation
Fig. 55 Applying Sealer Bead To Input Bearing
Retainer
Fig. 56 Aligning Retainer Oil Channel With Feed
Hole In Front Case
Fig. 57 Input Retainer Installation
Fig. 58 Shift Sector Installation
21 - 160
TRANSMISSION AND TRANSFER CASE
ZJ
DISASSEMBLY AND ASSEMBLY (Continued)