Jeep 1996 Grand Cherokee Service Manual - page 1210
in
counterclockwise
direction
(as
viewed
from front of case).
(13) Install new gasket at rear of transmission
case. Use petroleum jelly to hold gasket in place. Be
sure to align governor feed holes in gasket with feed
passages in case (Fig. 162). Also install gasket before
overdrive piston retainer. Center hole in gasket is
smaller than retainer and cannot be installed over
retainer.
(14) Position overdrive piston retainer on trans-
mission case and align bolt holes in retainer, gasket
and case (Fig. 163). Then install and tighten retainer
bolts to 17 N·m (13 ft. lbs.) torque.
(15) Install snap ring that secures low-reverse
drum to hub of piston retainer (Fig. 164).
(16) Install rear band lever and pivot pin (Fig.
165). Align lever with pin bores in case and push
pivot pin into place.
(17) Install planetary geartrain assembly (Fig.
166).
(18) Install thrust plate on intermediate shaft hub
(Fig. 167). Use petroleum jelly to hold thrust plate in
place.
Fig. 162 Installing/Aligning Case Gasket
Fig. 163 Aligning Overdrive Piston Retainer
Fig. 164 Installing Low-Reverse Drum Retaining
Snap Ring
Fig. 165 Rear Band Lever And Pivot Pin Installation
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 71
DISASSEMBLY AND ASSEMBLY (Continued)