Jeep 1996 Grand Cherokee Service Manual - page 1429
(5) Install and tighten the blower motor mounting
screws.
(6) Connect the wiring connector and install the
wiring into the retainer.
(7) Connect the blower motor cooling tube.
(8) Connect the battery negative cable.
BLOWER MOTOR RESISTOR/POWER MODULE
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Unplug the blower motor resistor/power module
connector.
(3) Remove the resistor/power module retaining
screws.
(4) Remove the blower motor resistor/power mod-
ule (Fig. 38).
INSTALLATION
(1) Install the blower motor resistor/power module.
Install and tighten the screws.
(2) Connect the resistor/module connector.
(3) Connect the battery negative cable.
HIGH SPEED BLOWER MOTOR RELAY
This relay is used only on models equipped with
the optional ATC system.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Locate the relay near the right end of the heat-
er-A/C housing under the instrument panel (Fig. 39).
(3) Unclip the relay connector from the side of the
heater-A/C housing.
(4) Unplug the relay from the connector.
INSTALLATION
(1) Align the relay terminals with the cavities in
the relay connector.
(2) Push the relay firmly into the connector.
(3) Clip the relay connector back on the side of the
heater-A/C housing.
Fig. 37 Blower Motor Seal
Fig. 38 Blower Motor Resistor/Power Module
Fig. 39 High Speed Blower Motor Relay
24 - 38
HEATING AND AIR CONDITIONING
ZJ
REMOVAL AND INSTALLATION (Continued)