Jeep 1996 Grand Cherokee Service Manual - page 1188
(19) Remove adjusting screw bracket, line pressure
adjusting screw, pressure regulator valve spring and
switch valve spring (Fig. 78). Do not remove throt-
tle pressure adjusting screw from bracket and
do not disturb setting of either adjusting screw
during removal.
(20) Loosen
left-side
3-4
accumulator
housing
attaching screw about 2-3 threads. Then remove cen-
ter and right-side housing attaching screws (Fig. 79).
(21) Carefully
rotate
3-4
accumulator
housing
upward and remove 3-4 shift valve spring and con-
verter clutch valve plug and spring (Fig. 80).
(22) Remove left-side screw and remove 3-4 accu-
mulator housing from valve body (Fig. 81).
(23) Remove pressure regulator valve spring from
lower housing (Fig. 82).
Fig. 78 Adjusting Screw Bracket And Spring
Fig. 79 Accumulator Housing Screw Locations
Fig. 80 3-4 Shift And Converter Clutch Valve
Springs And Plug
Fig. 81 Accumulator Housing, Valve Springs And Plug
Fig. 82 Lower Housing Valve Spring Locations
ZJ
TRANSMISSION AND TRANSFER CASE
21 - 49
DISASSEMBLY AND ASSEMBLY (Continued)