Quanta Computer QuantaMesh User Manual - page 101
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
101
This command adds a protocol-based VLAN group to the system. The <group-name> is a character
string of 1 to 16 characters. When it is created, the protocol group will be assigned a unique number that
will be used to identify the group in subsequent commands.
Syntax
switchport protocol group
no switchport protocol group
no - This command removes the protocol-based VLAN group that is identified by this
Default Setting
None
Command Mode
Global Config
This command adds all physical interfaces to the protocol-based VLAN identified by <group-name>. A
group may have more than one interface associated with it. Each interface and protocol combination can
only be associated with one group. If adding an interface to a group causes any conflicts with protocols
currently associated with the group, this command will fail, and the interface(s) will not be added to the
group.
Syntax
switchport protocol group all
no switchport protocol group all
all - All interfaces.
no - This command removes all interfaces from this protocol-based VLAN group that is identified by
this
Default Setting
None
Command Mode
Global Config